In this article let us learn How to Bridge Two Car Audio Amps in six easy steps and the advantages of bridging two car amplifiers with tips and warning for doing this job perfectly. Let us learn to get it right the first time itself because wrong connection may blow out the speakers or even burn the amps or sometimes in the worst case both may happen.
The easiest way to improve and enhance the sound of speaker is to connect two car amplifiers together . This also gives lot of power for bigger speakers such as woofers. We may need few things before we start doing this job . They are wrenches, pliers, wire strippers, wire rated for the amplifiers and of course the two amplifiers which we are planning to bridge.
The first step is to carefully study the instruction manual to ensure which two amplifiers can be connected together. Power compatibility will determine if the bridge would be safe or not. Sometimes we may have a doubt if these two amps can be bridged. In that case don't make an attempt to do that as it may burn the amps. Safe bridging is very important or else the loss incurred from improper connection may become very expensive.
Before attempting to perform the operation please make sure to power down both the amplifiers. It is as simple as it is just disconnection of them from the power supply. There is one easy way to do this. It is just disconnecting from the car battery the positive cable clamp either with wrenches or pliers so as to keep it inactive throughout the process of bridging.
There will be a bridge switch at the rear end of each amp usually. Turn on that switch in case if it is there. Take a wire . Remove the insulation to about half inch in both the ends of the wire taken.
Every amp has a positive terminal and a negative terminal . For easy identification red color terminals are positive and black are for negative terminals. Next step is to make a connection between positive terminal of one of the amps with one end of the wire. The other end of the wire is attached to negative terminal of another amp. Make the connections tight by screwing the knobs. This process is called bridging of amps.
The speakers and the terminals in the bridged amplifier can be connected by the wire. The positive wire is connected to the terminal which is positive and in the same way negative is connected to the negative of the speaker.
One must know how to bridge two car audio amps, using which he can improve his speaker sound easily.
Looking to find the best deal on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you.